ZenithOwner.com
ZenithOwner.com Forum LinkZenithOwner.com Home ButtonZenithOwner.com Builder's ListZentihOwner.com DownloadsZenithOwner.com Contact
LEARN | BUILD | FLY
Zenith 750 Cruzer In order to make cut the carpet properly, I bought a roll of masking paper at Home Depot. Then I measured all of the sides around the perimeter of the area I wanted to carpet.

I transferred those measurements on to the paper and cut it out. After installing it to test the fit, I used the paper as a template to cut out the carpet.

   
Zenith 750 Cruzer Here's I'm marking where slots will need cut.
   
Zenith 750 Cruzer Fits good.
   
Zenith 750 Cruzer And here's the carpet. At this point, there is nothing holding the carpet down. It just seems to lay in place very nicely.

I'll use a few pieces of carpet tape to hold it in place once I want to install it permanently.

   
Zenith 750 Cruzer Now I need to make the aft bulkhead piece. That piece will have the Blue Angels logo embroidered on it.
   
Zenith 750 Cruzer  
   

Home