ZenithOwner.com
ZenithOwner.com Forum LinkZenithOwner.com Home ButtonZenithOwner.com Builder's ListZentihOwner.com DownloadsZenithOwner.com Contact

LEARN | BUILD | FLY


 

Zenith 750 Cruzer Installed this return fuel line from the firewall to the fuel selector.
   
Zenith 750 Cruzer I use a soldering iron to burn a hole in the carpet where the bolts for the seats go. The pilot seat is done and today I finally made the holes to mount the passenger seat.
   
Zenith 750 Cruzer Use these adel clamps to holes the ignition wires away from the spinning starter gear.
   
Zenith 750 Cruzer You're looking at the exhaust hanger between the muffler pipes with a hose clamp holding it secure to the muffler. The top bolts to the engine.
   
Zenith 750 Cruzer Here is the cabin heat muff. I just ordered two 5" hose clamps to clamp it in place. Then I just need to connect the tubes and it's done.
   
Zenith 750 Cruzer The prop is installed and it's just about ready for engine start.

Do I have have a secret project?? Hmmm...are those helicopter blades on the floor??

   

Home