ZenithOwner.com
ZenithOwner.com Forum LinkZenithOwner.com Home ButtonZenithOwner.com Builder's ListZentihOwner.com DownloadsZenithOwner.com Contact
LEARN | BUILD | FLY
Zenith Cruzer I installed the nose gear and then removed it to have it powder coated. When I went to pick it up, there was a large chip in the coating so they have to do it again. I'm hoping to get it back tomorrow and then I can put the nose gear on.
   
Zenith Cruzer The fuselage (even without the nose gear) is on the wheels and off the work bench!
   
Zenith Cruzer The the fuse off the table, I put a wing on it to finish up some small items on the wings.
   
Zenith Cruzer Once I get the nose gear back from the powder coater, I can attach it and the nose wheel. Then I will temp install the engine mount and add some weight to it to get the tail off the ground.

Then the plan is to get the torque tube fit and the elevator cables attached along with the vertical tail.

   

Home