ZenithOwner.com
ZenithOwner.com Forum LinkZenithOwner.com Home ButtonZenithOwner.com Builder's ListZentihOwner.com DownloadsZenithOwner.com Contact
LEARN | BUILD | FLY
Zenith 750 Cruzer Since there are items fwf that need grounded, I added a grounding block forward of the firewall instead of running all these wires through the firewall. From left to right are grounds for the right ignition module cable, left ignition cable, fuel pump 1, fuel pump 2, and at the end the 14AWG wire that grounds the block to the airframe.

I will have two more connections-one for the fuel pressure sensor, and one for the oil pressure sensor.

   
Zenith 750 Cruzer All of the oil lines are connected now.
   
Zenith 750 Cruzer After making the mounts for the two red cube fuel flow transducers, I found out from Roger (at Zenith) and Ray (at UL Power) that with the new red ECU (which I have) I don't need to install the transducers. That info can be calculated from the ECU and sent to the Dynon.

So I removed the mounts for the transducers and connected up all the fuel lines.

   
Zenith 750 Cruzer This is the 14AWG wire from the starter solenoid to the key.
   
Zenith 750 Cruzer These are the two ground wires to the fuel pumps.
   

Home