ZenithOwner.com
ZenithOwner.com Forum LinkZenithOwner.com Home ButtonZenithOwner.com Builder's ListZentihOwner.com DownloadsZenithOwner.com Contact
LEARN | BUILD | FLY
Zenith Cruzer

The instructions say to make this L 82mm. As you can see, 82 mm is too short! I had to make a new longer one as it is suppose to go all the way from front to back.

   
Zenith Cruzer

Here's the new one I made. Not sure why Zenith would not correct the manual.

   
Zenith Cruzer Match drilled and holes drilled to #20.
   
Zenith Cruzer The top piece fit fine.
   
Zenith Cruzer

After it was matched drilled to #20, I beveled the edges.

   
Zenith Cruzer

Finally, I scuffed and primed these pieces.

Next I will debur all the holes in the elevator and trim tab skins and then prime those parts and the entire elevator will be ready to rivet.

   

Home