ZenithOwner.com
ZenithOwner.com Forum LinkZenithOwner.com Home ButtonZenithOwner.com Builder's ListZentihOwner.com DownloadsZenithOwner.com Contact
LEARN | BUILD | FLY
Click the picture to the left for a video on how I made these pieces. The link takes you to the ZenithOwner.com forums where the video is posted.
   
Zenith 750 Cruzer I never liked how the brake lines come out of the bottom of the fuselage. I've been pondering how I want to route mine and I finally came up with a solution.

Here is a slot cut in the bottom of the fuse...

   
Zenith 750 Cruzer ...from the bottom...
   
Zenith 750 Cruzer See this video on how I made these pieces. It's simply a tube glued to a flat plate.
   
Zenith 750 Cruzer It gives the brake lines a very nice exit point from the bottom of the fuselage.
   
Zenith 750 Cruzer  
   
Zenith 750 Cruzer  
   
Zenith 750 Cruzer  
   
Zenith 750 Cruzer  
   
Zenith 750 Cruzer Since this piece is done (there was nothing to do to it) I wrapped it in the carbon fiber vinyl graphic material to see how it would look. I love it!
   
Zenith 750 Cruzer I finished the comm and transponder antennas today by crimping on the BNC connectors. You will need a special tool to crimp these.

Here's the one you will need on Amazon.com.

   
Zenith 750 Cruzer I made another tab to hold the comm antenna cable.
   
Zenith 750 Cruzer Here it goes up to the comm antenna.
   
Zenith 750 Cruzer You can see the routing of the comm antenna cable here.
   
I've also starting working on the recognition light in the wing. That update is under the WING section of my build log. Here's a direct link.  

Home