ZenithOwner.com
ZenithOwner.com Forum LinkZenithOwner.com Home ButtonZenithOwner.com Builder's ListZentihOwner.com DownloadsZenithOwner.com Contact
LEARN | BUILD | FLY
Zenith 750 Cruzer This morning I've re-mounted the top cable pulley further aft on the fuselage. Shown here are the two L angles I've made as stiffeners. These are riveted under the top skin.

Notice they go from edge to edge for maximum support.

   
Zenith 750 Cruzer Blurry pic but shows that the ends of the angles are beveled for a perfect fit.
   
Zenith 750 Cruzer Once the angles were clecod under the skin I drilled the holes for the pulley bracket.
   
Zenith 750 Cruzer All four holes are drilled.
   
Zenith 750 Cruzer Everything clecod in place to check fit.
   
Zenith 750 Cruzer Finally the L's are riveted under the skin and the bracket is clecod for now. I won't rivet it until after the airplane is primed.
   

Home