ZenithOwner.com
ZenithOwner.com Forum LinkZenithOwner.com Home ButtonZenithOwner.com Builder's ListZentihOwner.com DownloadsZenithOwner.com Contact

LEARN | BUILD | FLY


 

Zenith 750 Cruzer The first thing I did today was move the ceiling fan down. I bought an 8' steel pipe at Home Depot and drilled the ends to accept the fan and upper mount.

Moving the fan down 8" lets it grab the cold air in the lower half of the hangar and pull it up to circulate it.

   
Zenith 750 Cruzer I finished the pilot side cabin heat.
   
Zenith 750 Cruzer The cable needs two clamps where the cleco clamps are located but I am out of the correct size clamps. I really need two more black ones like the two you see right below it.
   
Zenith 750 Cruzer Butterfly valve.
   
Zenith 750 Cruzer Also working on the two cockpit fuel lines. The return line is complete, but the line to the engine will be determined once I install a firewall bulkhead fitting.
   
Zenith 750 Cruzer I took this and the next pic just because I think it's a cool angle to look at the airplane.
   
Zenith 750 Cruzer The airplane looks a million times better with the wheel pants!
   

Home