ZenithOwner.com
ZenithOwner.com Forum LinkZenithOwner.com Home ButtonZenithOwner.com Builder's ListZentihOwner.com DownloadsZenithOwner.com Contact

LEARN | BUILD | FLY


 

Zenith 750 Cruzer These are the plates I had painted white. I wanted them white so they look good, and my neighbor was getting ready to paint some white on his Velocity. So I volunteered him to paint these for me!
   
Zenith 750 Cruzer This is the oil line coming from the air/oil separator. It is secured to the back side of the side plate so that it doesn't hit the rotating gear.
   
Zenith 750 Cruzer Plate on the right side.
   
Zenith 750 Cruzer Here's the back side of the left plate. A voltage regulator is mounted here and a cooling duct is there to cool it.
   
Zenith 750 Cruzer Further out view...
   
Zenith 750 Cruzer The white plates look so much better than just leaving them bare aluminum.

See the white ground wire on the bottom right bolt? I don't think it goes there. I think it has to go to an actual ground. I'll have to double check the manual so be careful how you wire your engine!

   
Zenith 750 Cruzer The ECU is mounted on the inside of the firewall. Tomorrow I will buy a 2" hole saw and cut a hole in the firewall to pass this large connector through.
   
Zenith 750 Cruzer This is the firewall side.
   
Zenith 750 Cruzer Notice it is mounted on rubber mounts.
   

Home